Two Large Tanks in Idaho

This was a job that was done for a customer in Idaho. We installed 2 used 30,000 gallon tanks on new concrete saddles. We installed a 4″ pump and a 25 HP motor. We also installed a 601 compressor. Lines were welded. The customer anticipates adding additional tanks and there is a flanged end of piping where additional tanks can be connected in the future.

Two Large Tanks in Nevada

This is a job that was done for a customer in Nevada. We installed 2 used 30,000 gallon tanks on new concrete saddles. We installed a 4″ pump with a 25 hp motor. All the piping is welded stainless steel. The shutoff stations will both shutoff the flow of gas as well as the electricity.

Underground Tank in Idaho

This is a job that was done for a customer in Idaho. We installed a new 30,000 gallon underground tank and a used 18,000 underground tank. These tanks are located at different locations on the property. Each tank has an unloading bulkhead with 3 shutdown stations.

Improvements in Wyoming

This is a job that was done for a customer in Wyoming. The customer had purchased 2 30,000 gallon above ground tanks that had been in underground service. We had the tanks sandblasted, primed and painted. We installed the tanks on new concrete piers. We also installed a 3″ pump with a 10 HP motor.

Rail Tower in Nevada

This is a job that was done for a customer in Nevada. We installed 2 used 30,000 gallon tanks. We installed a deluge fire suppression system, and a rail tower.

Large Tank in Arizona

This is a job that was done for a customer in Arizona. We swapped out the 30,000 gallon tank that was in use for a newer used 30,000 gallon tank utilizing the same concrete piers. We installed 2 new bulkheads and piping while reusing as many valves as possible, and connecting to the existing pump.

Vaporizers in Utah

This was a job for a customer in Utah. We installed 2 Q480 vaporizers. We replaced black iron piping with stainless steel piping.